Interruptor manillar Yamaha XT 600 -'90 izquierda

Original left side handlebar switch assembly suitable for several Yamaha models: compatible with standard handlebars diameter 22mm. OEM part number Yamaha: 30X-83972-00, 30X-83972-01. Complete with 60cm wiring included (measured to the end of the shortest wire): 1 squared connector with 4 wires, 1 squared connector with 3 wires, 1 connector bulb H4 and 2 wires with pin connecotrs. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through.

Functions:

• horn with push button
• winkers with 3 static positions on/off/on
• lights with 2 static positions on/off and 2 static positions high/low

Dimensions:

• width: 42mm
• depth: 53mm
• height: without top switch 53mm, total 65mm

Tip: check your wiring harness and make sure the connectors will work. It's common for the starter button's on these bikes to wear out due to arcing or they can break for various reasons: corrosion and cracked solder joints on the stock switch make for an unreliable and unsafe switch. If you use an aftermarket handlebar please make sure that wire harness is long enough.