Interruptor manillar Honda CB 750 Four '72-'75 derecho OE-Réplica

OEM reproduction right side handlebar switch assembly suitable for several Honda models CB 550 and CB 750: compatible with standard handlebars diameter 22mm. OEM part number Honda: 35300-341-671. Complete with 6 wires 60cm long (measured to the end of the shortest wire): this is for use with a double-cable desmo throttle control push pull set up (you can just run a pull cable if you want). There is not a locator pin built into the switch like the stock ones but there is a hole in the switch that will accept the stock locator pin which keeps the assembly in place. This switch has the lights off function: it is handy to have since you can turn the lights off to save on power consumption during daytime riding.

Functions:

• ignition with push button start
• engine kill with 2 static positions off
• lights 2 static positions on/off

Dimensions:

• width: 52mm
• depth: 52mm
• height: without top switch 58mm, total 68mm
• throttle cable fixing thread: open M12, close M10

Tip: check your wiring harness and make sure the connectors will work. It's common for the starter button's on these bikes to wear out due to arcing or they can break for various reasons: corrosion and cracked solder joints on the stock switch make for an unreliable and unsafe switch. This is an easy part to replace if your wires aren't running through the handlebars, if they are, it requires removing the handlebars and feeding the wires through. If you use an aftermarket handlebar please make sure that wire harness is long enough.